Evident LogoOlympus Logo
Assistenza clienti

Informazioni sul prodotto

31 agosto, 2021
Notice to Users of the 3D Measuring Laser Microscope OLS5000 and OLS5100

Dear Valued Olympus Customer:

We, OLYMPUS CORPORATION, have recently found that the inspection of the measurement accuracy may be needed for the laser microscope OLS5000 and OLS51000 if any of the following cases applies.
To ensure continuing safety and reliability, weʼd like to inspect the applicable products listed below. If you have any of the applicable products and the following case applies, please contact Olympus.
Thank you for continuing support for Olympus products.

[Applicable products]
OLS5000-SAF, OLS5000-SMF, OLS5000-LAF, OLS5000-HSU, OLS5000-EAF, OLS5000-EMF, OLS5100-SAF, OLS5100-SMF, OLS5100-LAF, OLS5100-HSU, OLS5100-EAF
Objective MPLAPON20XLEXT

[Case that needs inspection]
The inspection of the measurement accuracy is necessary in the following case.
Please contact us if the following case applies.

  • If the setup of the objective MPLAPON20XLEXT was carried out by the customer:
    * “Setup” means the operation conducted according to the instruction manual “OLS5000/OLS5100 3D Measuring Laser Microscope, Data Acquisition, Section 17-2 Attaching, replacing and removing the objective”.

[Case that does not need inspection]

  •  If the setup of the objective MPLAPON20XLEXT was carried out by the dedicated engineer of Olympus:
    * This inspection is not necessary when combined with objectives other than MPLAPON20XLEXT.

[Contact information]
Please contact us using the form below.
Contact Us (olympus-ims.com)

* Please describe as “Regarding the 20X objective of OLS”.
* The names, addresses, telephone numbers and any other personal information supplied by the customer will not be used for any other purposes than those mentioned above.

<< Back

Sorry, this page is not available in your country
Let us know what you're looking for by filling out the form below.
Sorry, this page is not available in your country