Preamplifiers: Models 5660B, 5660C, 5662, 5670, 5676, 5678, 5682
The ultrasonic preamplifier models for use with ultrasonic flaw detection, thickness gaging, and acoustic emission instrumentation provide very low noise amplification of ultrasonic signals.
Olympus wideband series of Panametrics AC coupled, broadband preamplifiers provides very low noise amplification of ultrasonic signals ranging from 500 Hz to greater than 40 MHz. Specifically designed for use with ultrasonic flaw detection, thickness gaging, and acoustic emission instrumentation, our preamplifiers are a cost-effective solution in general applications requiring high gain/low-noise amplification of low amplitude ultrasonic signals.
Our preamplifiers are ruggedly housed, completely self-contained, simple to operate, battery or AC powered units. They offer performance features such as very low noise (5 µV peak-to-peak noise referred to the input in Model 5660B), input protection for high voltage transients such as transducer excitation pulses, and the ability to drive long coaxial cables (greater than 500 feet or 152 meters with Models 5660B and 5660C). Both fixed gain and switchable gain versions are available, and custom units with special gain or bandwidth are available on special order.
Certain ultrasonic applications require the addition of a separate preamplifier unit to standard test systems in order to provide the additional gain or broadband signal-to-noise enhancement necessary for optimum signal acquisition. This is often the case in industrial applications involving flaw detection or thickness gaging of thick sections of materials exhibiting high ultrasonic attenuation such as nodular cast iron, brass, bronze, austenitic steel, rubber, Teflon®, or
reinforced composites. A preamplifier is also an important component of acoustic emission test systems that require amplification of low signal amplitude events and the ability to drive long cables from remotely located sensors.
The Model 5682 Ultrasonic Preamplifier provides low noise amplification of ultrasonic signals ranging from 500 KHz to 25 MHz. The preamplifier, housed in a rugged enclosure, is very small and lightweight making it ideally suited for remote applications. The preamplifier can be powered with either a single 9 V battery for up to 50 hours of continuous operation or a local 9 V to 13 V DC supply (customer supplied). When battery operated, a multicolored LED provides
feedback on battery status. This preamplifier is ideal for AUT and TOFD scanning.
*All specifications are subject to change without notice.
NEW - Model 5682 Ultrasonic Preamplifier
|Voltage Gain: 30 dB @ 10 MHz
HighPassRollover: 0.5 MHz +/- 0.1 MHz
LowPassRollover: 31 MHz +/-1 MHz
Equivalent Input Noise: 11.5 µV RMS
Input Impedance: Nominally 700 ohms
Output Impedance: Nominally 50 ohms
Output Voltage: 2.5 V pk-pk
Protection: 500 V peak
Current Consumption: Nominally 14 mA
Power: 9 V alkaline battery or 9-13 V DC input (toggle switch)
Power Monitor: Three color LED for continuous power level indications
• Green: 7.0 - 9.0 V
• Yellow: 6.5 - 7 V
• Red: 5.0 - 6.5 V
• No light: <5.0 V (Low charge, replace battery)
>50 hours continuous operation
Connectors: Lemo® 00 Type
Dimensions: 2.25" x 4.3" x 1.1",
57.15 mm x 109.22 mm x 27.94 mm
6.4 oz, 181 gr with battery;
4.8 oz, 136 gr without battery
32° F to 122° F;
0° C to 50° C