Evident LogoOlympus Logo
두께 및 결함 검사 솔루션

Transducer Selector

Please choose your material below to see relevant transducers.

검색 결과가 없습니다.

High Resolution

Measurement to 0.0001 in. or 0.001 mm resolution. Usually recommended only when measuring smooth, acoustically transmissive materials like most metals and ceramics with delay line transducers.

Small Radius

Measurement on curved surfaces with radiuses smaller than approximately 50 mm or 2”. This requires small diameter transducers.
Below 1.000” OD: Use 0.250” diameter transducer or smaller
Below 0.500” OD: Use 0.125” diameter transducer or smaller
Below 0.250” OD: Use V260 Sonopen
Below 0.125” OD: Use immersion transducers
Consult Olympus for details.

High Temperature

Surface temperature greater than 50º C or 125º F. In such cases a high temperature delay line transducer must be used.

Precision Thickness Gage Transducer Ranges for Metals, Plastics and Miscellaneous Materials

These tables are intended as a general guideline only, listing only the most commonly used Microscan transducers and typical material thickness ranges when used with the Olympus Model 38DL PLUS and 45MG gages (45MG-SE or 45MG-HP software option required.) All thickness ranges are approximate and should be used as a starting point. The actual measurement range in a given case will always depend on instrument setup as well as material properties such as part geometry, surface condition, and grain structure.

In many cases, these measurement ranges will require an optimized gage setup where gain and blanking have been adjusted by a trained operator. The pre-programmed transducer default setups can always be used as a starting point, but performance can be often optimized and range extended with some simple setup adjustments. Contact Olympus for details.

Your choices also depend on geometry, temperature and resolution. Please consider the follloiwng before making your selections.

NameDescription
High Resolution Measurement to 0.0001” or 0.001 mm resolution. Usually recommended only when measuring smooth, acoustically transmissive materials like most metals and ceramics with delay line transducers.
Small Radius Measurement on curved surfaces with radiuses smaller than approximately 50 mm or 2”. This requires small diameter transducers.
Below 1.000” OD: Use 0.250” diameter transducer or smaller
Below 0.500” OD: Use 0.125” diameter transducer or smaller
Below 0.250” OD: Use V260 Sonopen
Below 0.125” OD: Use immersion transducers
Consult Olympus for details.
High Temperature Surface temperature greater than 50º C or 125º F. In such cases a high temperature delay line transducer must be used.

죄송합니다. 이 페이지는 해당 국가에서 사용할 수 없습니다.
아래 양식을 작성하여 원하는 내용을 알려주십시오.
죄송합니다. 이 페이지는 해당 국가에서 사용할 수 없습니다.