Changing the Phased Array Probe
Changing the probe on the RollerForm
requires disassembly of the tire and wheel.
Two tools are required - a hex key and a retaining clip remover.
Remove the probe orientation indicator.
Remove two hex screws.
Turn the assembly over and remove the other two hex screws.
and remove the tire and wheel assembly from the scanner.
Remove the bushing.
Using the retaining clip removal tool,
remove the retaining clip.
And pull the probe free from the tire and wheel assembly.
Insert the new probe back into the tire and wheel assembly.
Re-install the retaining clip.
Re-install the bushing.
Replace the hex screws.
Re-install the hex screws on the other side.