1
00:00:06,340 --> 00:00:10,955
Changing the Phased Array Probe

2
00:00:10,956 --> 00:00:13,211
Changing the probe on the RollerForm

3
00:00:13,213 --> 00:00:18,776
requires disassembly
of the tire and wheel.

4
00:00:18,778 --> 00:00:26,376
Two tools are required - a hex key
and a retaining clip remover.

5
00:00:26,378 --> 00:00:34,350
Remove the probe orientation
indicator.

6
00:00:34,351 --> 00:00:43,418
Remove two hex screws.

7
00:00:43,420 --> 00:00:55,375
Turn the assembly over and
remove the other two hex screws.

8
00:00:55,376 --> 00:01:00,198
and remove the tire and wheel
assembly from the scanner.

9
00:01:00,200 --> 00:01:05,811
Remove the bushing.

10
00:01:05,813 --> 00:01:09,355
Using the retaining clip
removal tool,

11
00:01:09,356 --> 00:01:15,623
remove the retaining clip.

12
00:01:15,625 --> 00:01:22,070
And pull the probe free from the
tire and wheel assembly.

13
00:01:22,071 --> 00:01:28,743
Insert the new probe back into the
tire and wheel assembly.

14
00:01:28,745 --> 00:01:40,485
Re-install the retaining clip.

15
00:01:40,618 --> 00:01:50,586
Re-install the bushing.

16
00:01:57,968 --> 00:02:14,080
Replace the hex screws.

17
00:02:23,815 --> 00:02:36,343
Re-install the hex screws
on the other side.