Olympus is proud to introduce
two new dual element transducers
for use with the 27MG,
45MG, and 38DL PLUS ultrasonic thickness gages.
The D7912 and D7913 are 10 MHz
dual element transducers
with a small tip diameter of 0.295 in., or 7 mm.
They are designed for making thickness measurements
on thin walled, small diameter tubes and pipes
at temperatures below 125 degrees Fahrenheit
or 50 degrees Celsius.
The thickness measurement range for these transducers
is approximately twenty thousands of an inch to one inch
or zero point five millimeters
to twentyfive point four millimeters
depending on the material and applications.
Use of the instrument’s gain adjustment
may be required to achieve the full thickness range.
The D7913 is a right angle transducer
with a potted cable
and rubber over molded strain relief.
This transducer is great for applications
with limited height requirements.
The D7912 is a straight version
with a potted cable and over molded bell housing
strain relief.
Both the D7912 and D7913
are constructed with a stainless steel case
for excellent wear resistance.
These dual element transducers are designed
to meet the center frequency specification
of EN15317.
The D7912 and the D7913
Along with our lower cost 5 MHz D7910
Are great additions to the Olympus line
of high quality corrosion thickness gage transducers.
For more information, contact your local sales representative
or visit our website at www.olympus-ims.com.