TRPP 5810

The TRPP 5810 unit is a high-performance remote pulser/preamplifier dedicated to TOFD inspection and compatible with the Olympus scanner line as well as PV-100 and PV-200 weld inspection systems.

This remote pulser/preamplifier provides an optimum signal-to-noise ratio for TOFD inspection by combining a 40 dB preamplifier with a remote high-voltage (200 V) pulse repeater in a single, small enclosure. The TRPP 5810 supports two UT channels, enabling simultaneous inspection with one or two pairs of TOFD probes.

Application

The TRPP 5810 can be used as a pulser and/or preamplifier.

TRPP 5810 as a Pulser

• Provides an additional pulse gain in order to generate a stronger signal when needed to reveal difficult-to-detect flaws.

TRPP 5810 as a Preamplifier

• Provides the additional gain or broadband signal-to-noise enhancement necessary for optimum signal acquisition on thick sections of material exhibiting high ultrasonic attenuation.
• Allow driving of long cables from remotely located sensors.

Pulser

• Remote, high-voltage (200 V) pulse repeater
• PRF of up to 10 kHz at 100 ns per channel and up to 20 kHz at 50 ns for a single channel
• Outputs are protected against misuse and bad connection to pulser outputs.

Preamplifier (Receiver)

• 40 dB preamplifier
• Accommodates probe frequency range from 1 MHz to 15 MHz.
• Inputs and outputs are protected against misuse and bad connection to pulser outputs.

General Features

• Withstands pulsed voltages up to 300 V for pulse widths in excess of 500 ns at PRFs up to 10 kHz.
• Dimensions (W×H×L): 57 mm×32 mm×90 mm
• Weight: 300 g
• UT connectors: 8×LEMO (00) female coaxial
• Water/moisture resistance: NEMA 4-IP66 or better. Rustproof.
• Casing material: Aluminum
• Powered by an external 12 VDC source or from instrument.
• Power connector: Compatible with standard Olympus umbilical cables (male Fisher 103 type)
• Red power-on LED indicator
• Operating temperature range: -10 °C to 60 °C
• Storage temperature range: -20 °C to 70 °C

Specifications