Fibrocópios Industriais, inicialmente desenvolvidos e aprovados para o motor PT6 da Pratt & Whitney, mas desde então têm sido usados para inspeções em pequenos motores e tubagens de pequeno diâmetro

There are some RVI applications that cannot be satisfied by a standard model fiberscope. Olympus has always been at the forefront of application solutions, and when a situation arises where a standard instrument will not provide the desired results, then Olympus has responded with advice on optimal instrument use in that application. This occasionally results in the introduction of a special instrument designed to meet that specific requirement - these are therefore known as special feature fiberscopes. This is not to say, however, that they cannot be used in other applications. The information below describes each model, together with its design application, but the specification may well suit a particular inspection you need to undertake.

IF5D4X1

At 5.0mm (0.19") diameter and 1200mm (47") working length, this instrument was initially developed and approved for the Pratt & Whitney PT6 engine, but has since become used for the inspection of many small engines and fine diameter pipework. It features two-way angulation, and interchangeable optical tip adaptors, allowing direct or side view, both supplied as standard with the instrument.

Back to top