Produtos Obsoletos

1700

The Nortec® 1700 is designed for the customer that requires conductivity testing only.

Specifications:lawMaster™ is a Microsoft® Windows® 98/Me/NT/2000/XP program, which provides a user-friendly interface for communications between the flaw detector and an IBM compatible PC. A-Scans, instrument settings, thickness readings, and report contents are all available for review, archiving, uploading and downloading.

60 or 480 KHz operation
0.9 - 110% IACS
0.0 - 0.025 inch non-conductive thickness readings
Large selection of probe configurations with reject LEDs
Fast, simplified sorting of metal alloys
Verification of aluminum heat treatment
Interchangeable probes require no factory calibration of instrument to probes

The Nortec® 1700 replaces the original Nortec® 17, once the standard in conductivity testing. Once setup is complete, alloys and heat-treated conditions or paint thickness can be checked automatically using the instrument's Go/No-Go alarm.

NORTEC® 1700 Technical Specifications
Conductivity Range: Digital conductivity display from 0.9% to 110% IACS. (International Annealed Copper Standard)

Accuracy: Within ± 0.5% IACS from 0.9% to 62% IACS and within ± 1% of values over 62%. Meets BAC 5651. Conductivity measurements with greater than 10 mils of lift-off have reduced accuracy.

Non-Conductive Coating Thickness: Can measure non-conductive coating thickness from 0.00" to 0.025". Accuracy of ± 0.001" over 0.00" to 0.015" range.

Alarms: Independent high and low limit alarms can be set for conductivity and lift-off. The alarms can be set to trigger when values are inside the limits (positive) or outside the limits (negative).

PowerLink™: Automatic probe recognition.

GENERAL

Dimensions: L = 9.5 in., W = 5.5 in., D = 3.5 in.; excluding handle (241 mm x 140 mm x 89 mm).

Weight: 6 lbs. (2.7 kg) with 2 Ni-MH batteries, 4.8 lbs. (2.1 kg) with 1 battery, 3.6 lbs. (1.6 kg) without batteries.

Display: Monochrome Backlit Liquid Crystal Display; 4.0 x 3.0 in. (5.0 in. diagonal), 320H x 240V pixels. Optional customer-interchangeable Hi-Brite Electroluminescent (EL) display.

Operating Temp: -4º to 140º F (-20º to 60º C).

Storage Temp: -40º to 176º F (-40º to 80º C).

POWER

DC: Two DR-35 Ni-MH batteries. Optional DR-35 battery pack or D-Cell belt pack.

AC: External charger eliminator will charge the internal battery and simultaneously operate a instrument from 90 to 264 volt, 50/60 Hz mains. Charging time is approximately 3 - 4 hours per battery pack.

Low Battery: Display bar graph "gas gauge" indicates approximate operating time. A low battery annunciator indicates when approximately 15 minutes of operation are left.

Battery Run Time: 8+ hours

Humidity: Safe operation in exposure to Class 3 temperature/humidity environment (-10° C to 55° C at 95% ± 5% relative humidity).

Hazardous Area Operation: Safe operation in explosive atmospheres as defined by Class 1, Division 2, Group D, as found in the National Fire Protection Association Code 0 (NFPA70), section 500 and tested using MIL-STD-810E, Method 511.3, procedure 1.