OmniScan MX 2.0 Release Notes

Welcome to Olympus NDT OmniScan MX 2.0 release notes. This release contains the following fixed bugs and enhancements that have
been reported on previous versions. Before upgrading, make sure to read the following document: 
Updating_OmniScan_MX_Software_(EN).pdf (DMTA044-01EN_A)


OmniScan MX 2.0R16 to MXU 2.0R18

14218 	Crash with Auto 80% in a sectorial configuration has been fixed.
15966	Correction of the scan offset on a TOFD group.


OmniScan MX 2.0R12 to MXU 2.0R16

12482 	SA^ reading is now correct when gate A is synchronized on gate I.
11417 	Sensitivity calibration is now possible when the index area is negative.
12433 	Gates are now placed correctly when moved with the mouse.
12425 	Changing to the time unit during analysis mode now works properly.
11592 	Loading .law files now refreshes the pulse width value properly.
11853 	Now is able to load particular 1.4 software setups.
11763   A% has been updated with a line at the 0 degree configuration in one-line scan. 


OmniScan MX 2.0R7 to MXU 2.0R12

11089 	Saving large data files is now faster.
10920 	The particular problem with file loading and saving of setups for Chinese and Japanese versions has been fixed.
10647 	A new gate editing mode using the mouse is now offered.
10875   Strip chart displays have been improved.
10673 	The problem with the data cursor when zooming on an S-scan is now fixed.
11311 	In UT mode, UT wedge angles parameters now give the angle in the material instead of the physical angle as in PA mode.
11018 	UT wedge files now include the model number.
10712 	Readings in LIN at 0° configuration now work correctly.
10143 	A scan area offset with LIN at 0° is no longer required.
10958 	The C-scan refresh with LIN at 0° mode is now improved.
11107 	Overlay display is now available with OD/ID parts.